Biostar M7MKB Motherboard Memory Upgrade

Give your Biostar M7MKB a performance boost by increasing its memory. With extra memory, you will also be able to run multiple programs at the same time.

Cheap memory is often the cause of random fatal exception errors, stop messages and reboots. Buy quality memory from here for a stable Biostar M7MKB system. The computer memory upgrade choices listed here have been tested for quality and compatibility with your Biostar M7MKB motherboard. In addition, you get a limited lifetime warranty and free technical support with your computer memory upgrade.

Biostar M7MKB Motherboard Specs:

• 168-pin DIMM Banking: 3 (3 banks of 1)
• Chipset: VIA Apollo KX133
• Error Detection Support: Non-ECC only
• Graphics Support: AGP 4X
• Max Unbuffered SDR SDRAM: 768MB
• Module Types Supported: Unbuffered only
• SDR SDRAM Frequencies: PC100 and PC133
• Supported DRAM Types: SDR SDRAM only
• USB Support: 1.x Compliant

These 168-pin DIMM modules are compatible with your M7MKB:

256MB SDRAM, PC133, CL=3, Unbuffered, Non-parity, 133MHz, 3.3V, 32Meg x 64

256MB SDRAM, PC100, CL=2, Unbuffered, Non-parity, 100MHz, 3.3V, 32Meg x 64

256MB SDRAM, PC133, CL=2, Unbuffered, Non-parity, 133MHz, 3.3V, 32Meg x 64

128MB SDRAM, PC100, CL=2, Unbuffered, Non-parity, 100MHz, 3.3V, 16Meg x 64

128MB SDRAM, PC133, CL=3, Unbuffered, Non-parity, 133MHz, 3.3V, 16Meg x 64

128MB SDRAM, PC133, CL=2, Unbuffered, Non-parity, 133MHz, 3.3V, 16Meg x 64

Biostar M7MKB Memory FAQ

What does PC100 and PC133 mean?

This is the front side bus (FSB) clock speed of the memory. It is okay to run faster rated memory even if the installed CPU uses a slower FSB.

What does the CL number mean?

Column Address Strobe (CAS) Latency, or CL for short, specifies how many clock cycles the Biostar M7MKB motherboard must wait before the memory module is ready to deliver the requested memory. The lower the CL number, the faster the access time.

However, the performance difference between CL=2 and CL=3 is so small that you will not notice any degradation in speed. Unless you are overclocking your Biostar M7MKB, you do not need to worry about the CL rating. If you are overclocking, then going with a lower CL may help stabilize your Biostar M7MKB motherboard.