AOpen AX3S Max Motherboard Memory Upgrade

Give your AOpen AX3S Max a performance boost by upgrading its memory. Besides better performance, you will be able to have more applications running at the same time.

Cheap memory is often the cause of random fatal exception errors, stop messages and reboots. Buy quality memory from here for a stable AOpen AX3S Max system. The computer memory upgrade choices listed here have been tested for quality and compatibility with your AOpen AX3S Max motherboard. In addition, you get a limited lifetime warranty and free technical support with your computer memory upgrade.

AOpen AX3S Max Motherboard Specs:

• 168-pin DIMM Banking: 3 (3 banks of 1)
• Chipset: Intel 815E
• Error Detection Support: Non-ECC only
• Graphics Support: AGP 4X
• Max Unbuffered SDR SDRAM: 512MB
• Module Types Supported: Unbuffered and Registered
• SDR SDRAM Frequencies: PC100 and PC133
• Supported DRAM Types: SDR SDRAM only
• USB Support: 1.x Compliant

These 168-pin DIMM modules are compatible with your AX3S Max:

256MB SDRAM, PC100, CL=2, Unbuffered, Non-parity, 100MHz, 3.3V, 32Meg x 64

256MB SDRAM, PC133, CL=2, Unbuffered, Non-parity, 133MHz, 3.3V, 32Meg x 64

128MB SDRAM, PC100, CL=2, Unbuffered, Non-parity, 100MHz, 3.3V, 16Meg x 64

128MB SDRAM, PC133, CL=2, Unbuffered, Non-parity, 133MHz, 3.3V, 16Meg x 64

AOpen AX3S Max Memory FAQ

What does PC100 and PC133 mean?

This is the front side bus (FSB) clock speed of the memory. It is okay to run faster rated memory even if the installed CPU uses a slower FSB.

Should I go with Unbuffered or Registered memory?

Go with whatever type of memory is currently in your AOpen AX3S Max motherboard. Registered memory will have one or more horizontal black chips that are smaller than the memory chips. If no memory is installed, you can go with either type but mixing types is not allowed. Registered memory can give you extra capacity at the expense of extra latency.

What does the CL number mean?

Column Address Strobe (CAS) Latency, or CL for short, specifies how many clock cycles the AOpen AX3S Max motherboard must wait before the memory module is ready to deliver the requested memory. The lower the CL number, the faster the access time.

However, the performance difference between CL=2 and CL=3 is so small that you will not notice any degradation in speed. Unless you are overclocking your AOpen AX3S Max, you do not need to worry about the CL rating. If you are overclocking, then going with a lower CL may help stabilize your AOpen AX3S Max motherboard.